The program controls the drying plant in the Repov brick factory. Using attachments, it makes measurements and on the basis of evaluations of these measurements it intervenes so that required results are achieved. The system is fully automated. It enables changing of parameters of installed peripheries, changing required values and browsing recorded data in several ways.

Introducing Repov program

• After starting the program, the drying plant schematic with the obtained data is displayed. These data change as if just being measured. In fact, they are read from the file created on the basis of real measurements.
• To display the meaning of the symbols, choose the menu item Informace | o Schematu.
• If asked for the password (Heslo), press the bar three times.
• You can display informatoin obout any sensor by choosing the menu item Informace | o cIdlech.
• You can also control the actuators directly from the computer by choosing the menu item Specialni funkce.
• Program enables you to display records in many ways, for example:
1. example
2. example
3. example

Recommended Hardware

• CPU 386 - 33MHz
• Standard VGA
• Memory 1MB
• 1MB on Hard Disk

Software Requirement

• MS-DOS 5.0 or higher
• Disk cache (Recommended)
• support for MS-DOS Page Font

Visit my Program Developing website

Send mail to profipohanka@volny.cz with questions concerning this website.
2005 Michal Pohanka | Last modified: 10-4-2005
You are the

visitor.